December 30, 2016 2 min read
We utilize the 1.2 nozzles with this kit and so the nozzle bungs were welded into the intake piping prior to the throttle body and 90 degree adaptors are used to aid with the tight clearances. You can see below that we mount the pump and the 2.5 gallon reservoir in the trunk of the vehicle and offer a custom mat to cover everything as to allow the vehicle to still remain stock looking. (The customer had installed dynomat into the trunk, this the silver lining).
With everything installed in the rear of the vehicle and all of the lines run to the engine bay, we proceeded with wiring the main control unit in the glove compartment and fabricating a customer gauge pod in the center cubby.
With everything tested and fitted it was time to hit the dynojet and see what type of horsepower we were going to put down, first with 93 pump and then with renegade race fuel via ecutek tuning.
The numbers were very good for pump 93 and water methanol on the stock motor, introducing the race gas really showed how well this system works as seen below.
Pushing close to 640 rwhp and 550 ft-lbs of torque on the stock motor in fourth gear, proving that with a proper setup and tune, you can make some serious horsepower on the stock bottom end! Please contact us today for inquiries about our water methanol kit, which is the same kit that we run on the quarter mile world record nismo 370Z, and any services for your nissan 370z or infiniti G37.